AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 95)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 95 (104)
8.3.1 PP configuration file (OMM database)
8.3.1.1 Supported Instructions
• start_number
Numbers can be generated automatically. This instruction defines the
start value
• no_of_number
If start_number is given, this instruction defines the maximum of
numbers which are generated
• ac (authentication code)
If set to “number”, ac will be equal to number. If a value is given it will
be taken as start value which is increased within each generation step.
• additional_pin
see ac
• sip_user
see ac
• sip_pw
see ac
8.3.1.2 Data section fields
The data sections contains the following field order:
1. Number
2. Name
3. AC
4. IPEI
5. Additional ID
6. Sip user name
7. Sip password
8.3.1.3 Example
PP configuration file:
# -----------------------#
# instruction section:
# -----------------------#
# -- start_number = {<start value for numbers to be generated>}
# -- no_of_number = {<maximum of generated numbers>}
# -- dect authentication code (ac) = {<"number">, <start value for ac's to be generated>}
# -- additionalId/userPin = {<"number">, <start value for id's to be generated>}
# -- SIP user = {<"number">, <start value for id's to be generated>}
# -- SIP password = {<"number">, <start value for id's to be generated>}
start_number = 5401
no_of_number = 10
ac = 1001
additional_pin = number
sip_user = number
sip_pw = number