AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 86)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 86 (104)
• Display of further events concerning the status or actions of IP DECT
Base Stations and telephones of the IP DECT system.
• All events can also be recorded in a log file
• Display of the synchronization relations between the RFPs
• Monitoring of systems with up to 256 IP DECT Base Stations and 512
PPs
• Reading out and display of IP DECT RFP statistics data, either for a
single IP DECT RFP or for all IP DECT RFPs.
• Display of DECT central data of the IP DECT system.
The DECT Monitor program can only be used when the DECT Monitor flag in
the OMM system configuration is enabled.
NOTE: Because of security, the DECT monitor flag is not stored permanently
in the internal flash memory of the OMM/RFP. After a reset the DECT
monitor flag is disabled.
The DECT monitor program is used together with the IP DECT system.
When the program is started, the user is requested to enter the IP address of
the IP DECT RFP or server running the OpenMobility Manager (OMM)
software.
There can be several reasons for an unsuccessful link establishment:
• Operation of DECT monitor is not enabled inside the OMM. Use the web
service to enable DECT monitor operation.
• IP address is not correct. It has to be the address of the RFP the OMM is
running on
• A link routed to the RFP is not supported.
The program displays the IP address which was used last time.
When the program is started a link to the OMM is automatically established
and program window shows all user configured child windows and tables.
When all links have been established, the DECT data of the system are
automatically read out and entered in the tables "RFP-Table" and "PP-
Table". This procedure is called "Config Request".