AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 29)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 29 (104)
IMPORTANT: Select the “yes” checkbox for the RFP to “Use local
configuration” otherwise DHCP will be used.
Press the “Send configuration” button to transmit the parameters to an RFP.
Boot Parameters (comply with DCHP options)
Parameter Type Meaning
Use local configuration mandatory The parameter defines whether the local configuration settings
should be used when booting or not.
IP Address mandatory IP address of the RFP
Net mask mandatory Subnet mask of the IP network
TFTP Server Address mandatory IP address of the TFTP server
TFTP File Name mandatory The boot file be read from the TFTP server at start-up.
OMM IP Address mandatory IP address of the OpenMobility Manager
Router addresses optional IP address of Default gateway
DNS Addresses optional IP address of DNS server
DNS Domain optional Domain name of the network
Broadcast Address optional The broadcast address for that network
2nd OMM IP Address optional IP address of the resilient/standby OMM
Country optional Defines the country in which the OMM resides to handle country
specific call progress tones.
NTP Server Address optional IP address of a NTP Server
NTP Server Name optional Name of a NTP Server
VLAN ID optional VLAN identifier
Syslog IP Address optional Destination IP address for the syslog
Syslog Port optional Destination port for the syslog
Restore URL optional URL for an automatic OMM Database import (see chapter
3.3.2.5)
OMM in proxy mode optional Expert Mode
The configuration can only be set after powering up or at the retry phase
(LED flashing 0,25 Hz) or in kernel mode, please see section 3.1 for details.
The configurator tool waits 2 seconds and retries transmitting the data 3
times.