AASTRA 6737i User Guide EN - Manual (Page 66)

Line Keys and Softkeys
59
41-001452-00 Rev 01 – 06.2013
In active states, such as ringing, conference, connected, etc., all softkeys disappear except softkeys that have been set up
as line/call appearances, and any context dependent softkeys required for the active state, such as the Drop softkey in
the connected state. Typically, context dependent softkeys appear in the top left position and all line/call appearance
softkeys appear in the remaining positions.
You use the Aastra Web UI to set a softkey as a line.
Configuring a Line Key
You can set a key as an additional line on the 6737i. The key acts as a line that behaves the same as a hard line key. For
more information about the behavior of line keys, see
“Multiple Line and Call Appearances” on page 52.
You use the Aastra Web UI to set a key as a line.
Use the following procedure to set a key to function as a line. The procedure shows the softkey screens as an example.
Note:
In some situations, such as during a conference call, the line/call appearance softkeys may overwrite some of the con-
text dependent softkeys. In this case, instead of the Previous and Next softkeys, up or down icons,
5 and 2 appear on
the display. By using the 5 and 2 navigation keys, you can access the same functionality as the Previous and Next
softkeys.
Aastra Web UI
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Expansion Module <N>.
Softkeys
2. Select from “Key 1” through “Key 10” on the Top keys.
or
Select from "Key 1" through "Key 20" on the Bottom keys.
3. In the "Type" field, select Line to apply to the key.
4. In the "Label" field, enter a label to apply to this key.
5. In the "Line" field, select a line to apply to this key.
Valid values are 5 through 9.