VEGA INSYS Modem GPRS 5.0 - Manual (Page 100)

FAQ INSYS GPRS 5.0 serial
100
Problem: Possible cause: Remedy
The manual selection of
ATD<ip>:<port>
or
ATD<domain>:<port>
is not possible. After a few
seconds, the messages No
Carrier
or No Dialtone
are displayed.
The GPRS dial-in parame-
ters have not been set cor-
rectly. Step 1:
Read out all data using the button “Read
settings” from the device and check the
settings.
Step 2:
On the tab "TCP transparent" check the
selection of the network provider.
For some network providers, PAP authen-
tication is required.
Please find a selection of network provid-
ers for German speaking countries (Ger-
many, Austria, Switzerland) in Chapter 11
“GPS Dial-in Parameters” or ask the cus-
tomer center of your provider for the cor-
rect settings.
Step 3:
Change the settings, if necessary and
restart the INSYS GPRS 5.0 serial.
Step 4:
Switch to the terminal program
and manually dial into the GPRS network.
Enter the AT command ATD*99***1#.
The successful connection setup is con-
firmed with the message Connect.