VEGA INSYS Modem GPRS 5.0 User Manual
Page 16
Mounting
INSYS GPRS 5.0 serial
16
8.
Connect the device to the PC.
Connect the 9-pin jack at the device with the serial interface of
your computer.
9.
Install the configuration software HSComm GPRS and/or your terminal
program.
10. Start the program HSComm GPRS on the PC.
11. Synchronize the serial interfaces of the PC and the INSYS GPRS 5.0 serial
At delivery, the serial interface settings of the INSYS GPRS 5.0 se-
rial are as follows: 8 data bits, no parity, 1 stop bit, data rate
19,200 Bits/s.
To synchronize the interfaces in the Software HSComm GPRS,
use the button "Synchronize RS232".
For the configuration, the settings of the serial interface of the PC and the
INSYS GPRS 5.0 serial must always be identical!
4.5.2 Driver installation
The installation of a driver is not required when using a terminal program or the
software HSComm GPRS. When using another application, a driver may be neces-
sary. Please find our current drivers at http://www.insys-tec.de/ or install the
standard modem 336 under Windows.