VEGA INSYS Modem GPRS 5.0 - Manual (Page 24)

Mounting INSYS GPRS 5.0 serial
24
6. Select the item "Serial port" in the TeraTerm menu under "Setup".
7. Set the connection parameters of the serial connection.
As default, the serial interface of the INSYS GPRS 5.0 serial is
configured with the following parameters: Baud rate 19,200, 8
data bits, no parity, 1 stop bit If you did not change these set-
tings in the INSYS GPRS 5.0 serial, use these parameters when
configuring the serial interface of the PC.
8. Select the item "Terminal" in the TeraTerm menu under "Setup".
9. Configure the terminal behavior.