VEGA Phoenix PSI Data Fax Modem - Manual (Page 101)

AT Commands
692302 6-13
%G Caller ID
%P Power-On Auto-Connect
The %P command specifies whether the modem automatically establishes a
connection with another modem when it is switched on.
%S Call-Back Security
\F Display all Stored Telephone Numbers
The command displays all 20 stored telephone numbers.
\L Check the Telephone Connection
This command executes a line test.
\S Receive SMS Messages
%G0 Disable the caller ID function.
%G1 Enable caller ID output. The caller ID is output to the RS-232 interface in
a specific format
%G3 Enable caller ID evaluation.
Selective call acceptance: Only calls from the stored caller IDs from &Z18
and &Z19 are accepted, regardless of register S0.
%P0 Configuration of the modem for normal operation (default).
%P1 Enable the auto-connect function. The modem automatically dials
telephone number x which was stored with the &Z0=x command (see
page 4-21).
%S0 Disable call-back security.
%S1 Enable call-back security with password validation.
%S2 Enable password validation.
\S0 Do not receive SMS messages.
\S1 Receive SMS messages. The telephone number for the SMS provider
must be stored under &Z20. SMS messages are output to the RS-232
interface in a specific format.
\S2 Control the modem via SMS Messages (see Section "SMS in the Fixed-
Line Network" on page 5-14).