VEGA Phoenix PSI Data Fax Modem - Manual (Page 104)

PSI-DATA/FAX-MODEM/RS232
6-16 692302
\C Set MNP Buffer
The \C specifies whether the modem stores received data in the buffer memory
while both modems are establishing a Reliable Connection (LAPM [Link Access
Procedure Modems] or MNP [Microcom Networking Protocol]). It also specifies
whether the modem should respond to the fallback character that was specified
with the %A command.
\E Echo
Your modem is set by default not to display an echo of the specified data on-screen
as long as the modem is in data mode.
\G DCE Flow Control (XON\XOFF)
The \G command enables or disables data flow control during a connection in
normal mode. Data control is required if the calling modem transmits data faster
than your modem can process it.
\C0 Instruct your mode to not store data in the buffer while a Reliable
Connection is being established. The fallback character is disabled.
\C1 Create buffers of up to 200 characters while establishing a Reliable
Connection. The fallback character is disabled.
When the buffer memory is full or four seconds have elapsed since the
connection was established, the modem establishes a standard
connection and sends the data stored in the buffer to your system.
\C2 Do not save data while establishing a connection. Detection of the
fallback character is enabled.
If the modem detects the fallback character while establishing a Reliable
Connection, it automatically switches back to normal mode.
\E0 Disable the echo function (default). The echo function is disabled in
Reliable Mode.
\E1 Enable the echo function. You can view on-screen all the data that is
exchanged between your modem and the partner modem.
\G0 Disable data flow control (default).
\G1 Enable data flow control.