VEGA Phoenix PSI Data Fax Modem - Manual (Page 87)

Special Functions
692302 5-17
5.8 Setting a Partner Output
5.8.1 Transmitting Local Inputs to the Partner Output
The PSI-DATA/FAX-MODEM/RS232 modem has one electrically isolated input
and one electrically isolated output. Alarm functions can be assigned to the input,
i.e., the partner output, for example, can be activated by activating the input.
The input configuration can be found in Section "Alarm Inputs and Alarms" on
page 5-4.
5.8.2 Switching the Partner Output via AT Commands
The PSI-DATA/FAX-MODEM/RS232 can be used to transmit its input to a partner
output.
Setting/deleting the partner output:
AT*AO<CR>
NUMBER<;>PASSWORD<;>COMMAND^Z:
Following the AT*AO command, you are prompted to enter the number, the
password, and the control command for the partner output. The number must end
with ;. The password length is limited to seven characters.
The following control commands are available:
RESET Resets the alarm and the switching output
(e.g., AT*AR).
SET:OUTPUT Activates the switching output ("Output").
CLR:OUTPUT Deactivates the switching output ("Output").
"Text" Outputs all the characters within the inverted commas
to the RS-232 interface.
After exiting the entry (Ctrl+Z) an attempt is made to contact the partner and
transmit the control command. The message is acknowledged by OK (successful)
or ERROR (unsuccessful). If unsuccessful, the command must be repeated.