VEGA Phoenix PSI Data Fax Modem - Manual (Page 84)

PSI-DATA/FAX-MODEM/RS232
5-14 692302
5.7 SMS in the Fixed-Line Network
You can send and receive SMS messages in the Deutsche Telekom fixed-line
network with the PSI-DATA/FAX-MODEM/RS232. SMS messages can only be
received if this feature has been enabled by Deutsche Telekom and an SMS
message is sent first to log in.
5.7.1 Sending SMS Messages
AT*AS<CR>
NUMBER<;>TEXT…^Z:
Following the AT*AS command, you are prompted to enter the number and text.
The number must end with ;. Exit the message with Ctrl+Z. The message must not
exceed 160 characters.
After exiting the entry (Ctrl+Z), the data is converted and the SMS is automatically
sent. The message is acknowledged by OK (successful) or ERROR (unsuccessful).
If unsuccessful, the command must be repeated.
The number for the SMS provider must be stored in store number 20 (AT&Z20). It
is set to Deutsche Telekom (01930100) by default.
5.7.2 Receiving SMS Messages
When SMS mode is enabled, SMS messages received are output to the RS-232
interface. To receive SMS messages, this feature must be supported and enabled
by your SMS provider. In addition, check that the caller ID (CLIP) is transmitted as
far as the modem (usually a problem for many older private branch exchanges).
The number for the SMS provider must be stored in store number 20 (AT&Z20). It
is set to Deutsche Telekom (01930100) by default.
Enabling SMS receipt using Deutsche Telekom as an example:
• Send an SMS with the text "ANMELD" to telephone number 8888.
• You can log off by sending the text "ABMELD" to telephone number 8888.