VEGA Phoenix PSI Data Fax Modem - Manual (Page 94)

PSI-DATA/FAX-MODEM/RS232
6-6 692302
DS=n Dial One of the Stored Telephone Numbers
The DS=n command instructs the mode to dial one of 20 telephone numbers,
where n is a value from 0 through 20. Use the &Z command to store telephone
numbers (see page 6-12).
Example: ATDS=1
The modem dials the telephone number in store number 1.
E Echo
Your modem is set by default to display commands on the PC screen in command
mode (echo). This feature is only necessary if your PC is configured for full duplex
mode.
! Dial an Outside Line/Divert Calls
Use this modifier to divert a call. Enter the telephone number that is to be
dialed first, then the ! modifier followed by the telephone number to which
the call is to be diverted. Once the modem has established a connection
with the first telephone number, it waits for two seconds and then diverts
the call.
> Dial an Outside Line via a Ground Button
; Return to Command Mode
If your modem is to call another modem and then return to command mode
without disconnecting, enter the ; modifier as the last character in your dial
command line.
L; DTMF Alarm Mode, Without Waiting for Silence
See Section "DTMF Alarm" on page 5-10.
K; DTMF Alarm Mode, With Waiting for Silence
See Section "DTMF Alarm" on page 5-10.
Most systems operate in full duplex mode. In this case, you can enable the echo
function with the E1 command.
If you are working in half duplex mode, you must disable the echo function with
the E0 command.