VEGA Phoenix PSI Data Fax Modem - Manual (Page 65)

Software Installation
692302 4-19
Result Codes Your modem is configured so that it outputs alphanumeric responses on-screen.
The "Numeric" option can be used if your software package or PLC only supports
numeric confirmations. The relevant settings can be found in Table 6-2 on
page 6-29.
Auto Answer Auto Answer (automatic call acceptance) enables you to specify the number of
rings after which your modem can automatically respond to incoming calls.
Automatic call acceptance is switched off by default upon delivery. Active automatic
call acceptance is indicated by the yellow "AA" (Automatic Answer) LED.
Dial Tone Detection When dial tone detection is switched on the modem waits for the dial tone before
dialing. Dial tone detection should be switched off in an private branch exchange.
Country Code Select the country where you wish to use your PSI-DATA/FAX-MODEM/RS232. If
your country is not listed, select Europe (CTR21) or the USA.
Speaker The internal speaker can be switched off, always on or only switched on when
establishing a connection.
Additional Settings Your modem has more functions than can be mapped in the configuration software.
To use these functions, enter additional AT commands in the "Additional Settings"
field.
The AT commands and their meanings are described in Section "Command
Descriptions" on page 6-4.
Example: Entering L3 increases the speaker volume.
This LED flashes in the event of an incoming call, regardless of automatic call
acceptance.
Additional settings can be saved in the project file via the "Save" button. However,
the are not read from the modem by the configuration software.