VEGA Phoenix PSI Data Fax Modem - Manual (Page 105)

AT Commands
692302 6-17
\J Set Serial Data Transmission Speed
The \J command specifies whether the data transmission speed between your
modem and your computer should be adapted to the transmission speed between
the two modems.
\K Process Break Character
The \K command specifies one of three options for processing the break character:
– Immediate disconnection with data loss
The buffer memory is deleted and the break character is transmitted
immediately.
– Immediate disconnection
The break character is transmitted before any data is stored in the buffer.
– Delayed disconnection
The break character is transmitted once the data in the buffer memory has
been sent.
Section "Processing the Break Character" on page 6-31 describes the various ways
in which your modem can process break characters.
\J0 Disable speed adjustment and use data compression.
This default setting enables the use of a high baud rate between your PC
and your modem, regardless of the connection speed between the two
modems. For example, you can set your DTE speed to 115,200 bps
regardless of the transmission speed between the modems.
\J1 Enable speed adjustment so that the serial data rate is automatically
adjusted to the rate between the modems.