VEGA Phoenix PSI Data Fax Modem - Manual (Page 82)

PSI-DATA/FAX-MODEM/RS232
5-12 692302
5.6 ASCII to Fax Conversion
The PSI-DATA/FAX-MODEM/RS232 supports ASCII to fax conversion. The
modem can automatically generate a fax from a simple ASCII string and send it.
The converted fax is limited to 30 kbytes, i.e., each line is limited to 60 characters.
First, the unique ID should be set once (AT+FLID="123"). It is stored in a non-
volatile memory and can be reset at any time.
Send an ASCII fax:
AT*AF<CR>
NUMBER<;>TEXT…^Z:
Following the AT*AF command, you are prompted to enter the number and text.
The number must end with ;. In the text, <CR> is the code for a line break, the ASCII
text is exited via Ctrl+Z. The maximum line length of 60 characters must not be
exceeded, after which a <CR> is automatically inserted. A maximum of
253 characters in total is permitted.
After exiting the entry (Ctrl+Z) the data is converted into a fax and the specified
number is dialed. The conversion may take a moment (approximately 30 seconds
to 1 minute). The fax is then sent. The fax is acknowledged by the hang-up
message (Class2) and OK (successful) or ERROR (unsuccessful). If unsuccessful,
the command must be repeated.
The following character set is used (characters that do not appear in this character
set are replaced by a space):
Table 5-1 Fax characters
Fax Characters ASCII Characters
20
hex
to 2F
hex
!,",#,$,%,&,’,(,),*,+,,,-,.,/
30
hex
to 3F
hex
0,1,2,3,4,5,6,7,8,9,:,;,<,=,>,?
40
hex
to 104F
hex
@,A,B,C,D,E,F,G,H,I,J,K,L,M,N,O
50
hex
to 5F
hex
P,Q,R,S,T,U,V,W,X,Y,Z,Д,Ц,Ь,Я,_
60
hex
to 6F
hex
´,a,b,c,d,e,f,g,h,i,j,k,l,m,n,o
70
hex
to 7F
hex
p,q,r,s,t,u,v,w,x,y,z,д,ц,ь,~