Grain Systems Unload Augers PNEG-1521 - Manual (Page 10)

DECALS
10
PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
Check the components shown below to insure that the safety decals are in place and in good condition. If
a decal cannot be easily read for any reason or has been painted over, replace it immediately. Contact
your dealer or the manufacturer to order a replacement decal free of charge.
SAFETY DECALS
Part # Description Size
DC-1266 Danger - Bin W ell 7-1/2" x 2-1/2"
DC-1384 Danger - Keep Out Of Bin 6-1/4" x 1-3/4"
DC-1866 Important - Power Sweep Information (? 42' Bin) 7-3/8" x 2-3/4"
DC-1834 Important - Power Sweep Information (36' Bin) 7-3/8" x 2-3/4"
DC-1395 Danger - Rotating Flight 4-1/4" x 6-1/4"
DECAL PART LIST
>
DC-1866
AUGER
TUBE
Outer Rod
Inner Rod
: Control for Inside
Intermediate Well
Gates (Pull To Open)
: Control for Center
Well Gate (Pull to Open)
IMPORTANT: BEFORE FILLING BIN CLOSE CENTER WELL
AND INTERMEDIATE WELL GATES. POSITION SWEEP
AUGER OVER INTERMEDIATE WELLS.
INSTRUCTIONS:
1. BE SURE POWER SWEEP CLUTCH CONTROL IS
DISENGAGED AND TIGHTEN SET SCREW.
2. START UNLOADING AUGER. OPEN CENTER WELL GATE.
3. WHEN GRAIN STOPS FLOWING FROM CENTER WELL
GATE, OPEN INSIDE INTERMEDIATE WELLS BEFORE
OPENING OUTSIDE INTERMEDIATE WELLS.
4. WHEN GRAIN STOPS FLOWING FROM OUTSIDE
INTERMEDIATE WELLS, STOP AUGER. TO ENGAGE
POWER SWEEP, ROTATE UNLOADING AUGER SLOWLY
UNTIL CLUTCH ENGAGES AND TIGHTEN SET SCREW.
START AUGER.
Control For Outside Intermediate
Well Gates (Pull To Open)
Power Sweep Clutch Control
(Pull To Engage Power Sweep)
DC-1866
DC-1266
• KEEP OUT OF BIN DURING UNLOADING
OPERATIONS.
• WHEN BIN WELLS ARE IN OPEN POSITION
CONVEYING MECHANISM IS NOT COVERED.
FAILURE TO HEED WILL RESULT IN
SERIOUS INJURY OR DEATH!
DC-1266
DC-1384
KEEP OUT OF BIN WHILE SWEEP IS IN OPERATION
RAPIDLY TRAVELING SWEEP AUGER
FAILURE TO HEED WILL RESULT IN
SERIOUS INJURY OR DEATH
DC-1384