Grain Systems Unload Augers PNEG-1521 - Manual (Page 37)

OPERATION
37
PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
15. PRE-START CHECKS
A. Make sure that ALL belt(s) are tensioned properly.
B. Make sure that ALL shield(s) are in place, and that the belt(s) and pulley(s) are able to move freely.
C. Inspect the drive unit for any problems, or potential problems.
D. Be aware of ALL emergency shutdown procedures. Two (2) people must always be in a position
where the operation of the equipment can be monitored.
E. Before starting the auger for the first time, make sure that all parts are assembled correctly
according to the instructions in this manual.
Failure to perform any and all of these pre-start checks may cause
damage to the equipment and could cause SERIOUS INJUR Y or DEATH
to those in the work area. A failure to perform any and all of these pre-
start checks may also be a misuse of the equipment, which may void the
warranty.
ALWAYS keep ALL guard(s) and shield(s) in place until all the power is
disconnected and locked out.
Make certain that ONLY trained operators are in the work area
before operating or moving the equipment. T wo (2) people must
always be in a position where the operation of the equipment can be
monitored.