Grain Systems Unload Augers PNEG-1521 - Manual (Page 31)

INSTALLATION
31
PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
N. Attach the second and third sections of Back
Shield to the Bearing Stand Assembly together
with the Carrier Wheel Assembly. Use two (2)
3/8" x 3-½” Hex bolts, four (4) flat washers, and
two (2) Nylock nuts.
11. INSTALLING THE SWEEP FLIGHTING
(Cont.)
O. Bolt the Shield Splice Plate to complete the
connection of the two Back Shields. Use four (4)
5/16" x ¾” Hex bolts, flat washers, and Serrated
Flange nuts.
P. The Carrier Wheel Assembly height can be
adjusted by using the 3/8" x 1" bolts on the Sweep
Carrier Body.
Q. Repeat Steps L & M until all Shield sections are
assembled.
Carrier Wheel
Assembly
3/8” x 1” Height
Adjustment Bolt
Second
Back Shield
Assembly
3/8” x 3-1/2”
Hex Bolt
Flat Washer
Bearing
Stand Assembly
Third
Back Shield
Assembly
5/16” x 3/4”
Hex Bolt
Flat Washer
Shield
Splice
Plate
5/16” Serrated Flange Nut
Flat
Washer
3/8” Nylock
Nut
FIG.11-L
FIG.11-M
Sweep Arms with three (3) or
more Flight and Shield sections,
a Carrier Wheel Assembly is
used. The Carrier Arm should
be installed after the first two
(2) sections of Flight and Shield.