Grain Systems Unload Augers PNEG-1521 - Manual (Page 19)

INSTALLATION
19
PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
6. CENTERWELL CONTROL GATE ASSEMBLY
Centerwell
Control Gate
Centerwell
Control Rod
Flat Washers
5/16” Serrated
Flange Nuts
1/2” Control Rod
Clamp
5/16” x 3/4”
Carriage Bolts
A. Close the Centerwell Control Gate completely.
B. Align the Centerwell Control Rod between the two
holes in the Centerwell Control Gate.
C. Attach the ½” Control Rod Clamp to the
Centerwell Control Rod by sliding 5/16" x 1-¾” roll
pin through the Clamp and the Rod.
D. Fasten the Control Rod Clamp to the bottom side
of the Centerwell Control Gate by using two
(2) 5/16" x ¾” Carriage bolts, flat washers, and
Serrated Flange nuts. Install the nuts so that they
secure the roll pin in place.
Inside Intermediate
Well Control Rod
Holes are Aligned
and Horizontal
Centerwell
Control Rod
Outside Intermediate
Well Control Rod
E. Adjust the Centerwell Control Rod and the
Intermediate Control Rods so that the second hole
on the Centerwell Control Rod and the hole on the
Intermediate Control Rod are aligned, and that
they are both horizontal.
This alignment is important for
proper gate control with the
Rack & Pinion.
5/16” x 1-3/4”
Roll Pin
FIG. 6-A
FIG. 6-B
F. Make sure all connections are tight.