Roof ring placement, Chapter 8: accessories – Grain Systems Tanks PNEG-4060 User Manual

Page 125

Advertising
background image

Chapter 8: Accessories

Use the following table as a guide to the location of each ladder step (rung).

Table 8-1 Ladder Rung Placement Chart

Bin Diameter

Location

54 ft.

60 ft.

Bin Peak

16

LS-260-2

15

LS-260-4

Roof Rib Hole Number From
Bin Eave

14

LS-260-3

LS-260-5

13

LS-260-4

LS-260-6

12

LS-260-5

LS-260-7

11

LS-260-6

LS-260-8

10

LS-260-8

LS-260-9

9

LS-260-9

LS-260-10

8

LS-260-10

LS-260-11

7

LS-260-12

LS-260-13

6

LS-260-13

LS-260-14

5

LS-260-14

LS-260-15

4

LS-260-16

LS-260-16

3

LS-260-17

LS-260-17

Bin Eave

2

LS-260-18

LS-260-18

1

LS-260-19

LS-260-19

NOTE: The table above shows the correct ladder step and part number to be installed in the corresponding

hole in the roof rib. Shaded areas also show the correct roof exhauster ladder step and part
number with the corresponding hole in the roof rib.

Roof Ring Placement

The roof ring is a tubular ring bolted to the exterior of the roof.

The placement location and quantity of roof ring kits vary with the size of each bin. The exhauster roof ring
(A) on the 60 ft bin will be installed in the seventh roof panel rib hole from the top. The eave roof ring (B)
will be installed in the last roof panel rib hole located at the eave end of the bin. The roof support ring (C)
will be installed in the ninth hole from the center collar.

NOTE: If ladder steps have been installed, and not already omitted, remove the ladder step that is installed

in the same roof panel rib hole in which the roof ring will be installed.

Pneg-4060 60 Ft Diameter 40-Series Bin

125

Advertising