Installing a roof ring, Chapter 8: accessories – Grain Systems Tanks PNEG-4060 User Manual
Page 126
Figure 8-2 Roof ring location on bin
A
Exhauster roof ring kit (CRP-7228-XX)
3
B
Eave roof ring kit (CRP-5496-XX)
4
C
Roof support ring (CRP-4799)
Installing a Roof Ring
Quantity and part numbers of roof ring kits vary with the location placement and with the size of each bin.
The following procedure will be similar for each kit.
What You Should Know
The roof ring and threaded stud may become dislocated from each other during high winds or when the
inside pressure of the bin is too great. If a threaded stud is dislocated, the entire roof ring will become dis-
jointed. To prevent this, drill holes through the roof ring and the threaded stud (after the rings have been
installed and expanded to the correct size) and insert a cotter pin or bolt through each hole. See
.
1. Determine the quantity of roof ring clips (C) needed for the roof ring section (B) being installed.
126
Pneg-4060 60 Ft Diameter 40-Series Bin
3.
(-XX) denotes the bin diameter.
4.
(-XX) denotes the bin diameter.