Grain Systems PNEG-526 - Manual (Page 163)

SERIES 72 MODUTROL IV™ MOTORS
63-2202—4 8
Wiring
CAUTION
Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment circuitry.
Disconnect all power supplies before installation.
Motors with auxiliary switches can have more than
one disconnect.
IMPORTANT
All wiring must agree with applicable codes,
ordinances and regulations.
1. Ensure that the voltage and frequency stamped on the
motor correspond with the power supply characteristics.
2. When connecting several motors in parallel, ensure that
the power supply VA rating is large enough to provide
power to all motors used without overloading.
3. Fig. 5 shows that motor terminals are quick-connects
located on top of the printed circuit board.
4. To access the wiring compartment:
a. Remove the four screws from the junction box top.
b. Lift off the cover.
5. Fig. 6 shows the internal wiring schematic.
6. Refer to Fig. 7 and 8 for typical wiring.
Wire the motor as follows:
1. Remove the wiring box cover by removing the four
screws holding the cover to the motor.
2. Wire motor to system using quick-connect terminals in
wiring box.
3. Replace wiring box cover.
Fig. 5. Terminals and adjustments.
RIGHT/INNER
AUXILIARY
SWITCH
INNER AUXILIARY
SWITCH CAM (BLUE)
POWER
END
OUTER AUXILIARY
SWITCH CAM (RED)
LEFT/OUTER
AUXILIARY
SWITCH
NOTE: FEATURES AVAILABLE ON SOME MODELS ONLY.
M5777
(+)
(-)
T2
T1
F
RIGHT/INNER
AUXILIARY
SWITCH
INNER AUXILIARY
SWITCH CAM (BLUE)
POWER
END
OUTER AUXILIARY
SWITCH CAM (RED)
LEFT/OUTER
AUXILIARY
SWITCH
NOTE: FEATURES AVAILABLE ON SOME MODELS ONLY.
Y(+)
T2
T1
F (TEST)
A B
V(-)
2 TO 10 VDC INPUT MOTORS 4 TO 20 mA NONADJUSTABLE INPUT MOTORS
NOTE: FEATURES AVAILABLE ON SOME MODELS ONLY.
4 TO 20 mA ADJUSTABLE INPUT MOTORS
C
SPAN ADJUST
POTENTIOMETER
START ADJUST POTENTIOMETER
START ADJUST MIN MAX
SPAN ADJUST MIN MAX
RIGHT/INNER
AUXILIARY
SWITCH
INNER AUXILIARY
SWITCH CAM (BLUE)
POWER
END
OUTER AUXILIARY
SWITCH CAM (RED)
LEFT/OUTER
AUXILIARY
SWITCH
T1
T2
(–)
(+)
F