Grain Systems PNEG-526 - Manual (Page 186)

50 Hanover Road, Florham Park, New Jersey 07932 www.ascovalve.com
Page 3 of 4 Form No.V6584R8
Torque Chart
Part Name Torque Value Inch-Pounds Torque Value Newton-Meters
solenoid base sub-assembly & adapter 175 ± 25 19,8 ± 2,8
pipe adapter 90 maximum 10,2 maximum
nameplate/
core
(AC) (DC)
solenoid base
sub-assembly
0.9375-26 UNS -2A
thread
core
red cap
finger
Tapped hole in core
0.250-28 UNF-2B
retainer
.062 to .093 maximum
thickness of panel
for mounting
0.69 diameter
mounting hole
push solenoid down.
Then pry here to lift
nameplate/retainer
Alternate
Construction Panel Mount 0.38 minimum full thread (DC)
0.63 minimum full thread (AC)
Remove red cap and
push solenoid down.
Then pry here to lift
nameplate/retainer
Remove red cap and
and push to remove.
and push to remove.
washer
finger washer
solenoid
with 1/2I NPT
grounding wire -
green or green with
yellow stripes
collar to face
valve body
Side View
Figure 1. Series 8003G solenoids
pipe adapter
plugnut gasket
plugnut assembly
solenoid base gasket
core(small end up)
retainer gasket
retainer
stem
disc
disc spring
bonnet washer
cutaway view to
show positioning
of retainer in
gasket recess
disc holder
adapter
adapter
gasket
disc holder
assembly
spring
solenoid base
sub-assembly
nameplate/
retainer
red cap
Air Only Construction
Vent to Atmosphere With
spacer
push solenoid down.
Then pry here to lift
nameplate/retainer
Remove red cap and
Adapter
Without
Adapter
and push to remove.
spring washer
grounding wire -
green or green with
yellow stripes
solenoid
with 1/2I NPT
Figure 2. Series 8202G solenoids Figure 3. 3-Way Construction