Grain Systems PNEG-526 - Manual (Page 187)

50 Hanover Road, Florham Park, New Jersey 07932 www.ascovalve.com
Page 4 of 4 Form No.V6584R8
Torque Chart
Part Name Torque Value in Inch-Pounds Torque Value in Newton-Meters
terminal block screws 10 ± 2 1,1 ± 0,2
socket head screw 15 - 20 1,7 - 2,3
center screw 5 ± 1 0,6 ± 0,1
screw terminal
adapter
gasket
DIN terminal
adapter
socket head screw
socket head
grounding screw
Open-Frame Solenoid
Open-Frame Solenoid Open-Frame Solenoid
with Screw Terminals.
Socket head screw is
used for grounding.
with DIN Terminals
tapped hole for
#10-32 grounding screw
(not included)
See
torque chart
above
terminal
block
screw
with 1/4I Spade Terminals
(5/32I hex key wrench) (5/32I hex key wrench)
Indicates parts supplied
in Termination Module
Kit No. K256104
z
z
z
z
z
z
z
Figure 4. Open-frame solenoids
cover screw
cover gasket
cover
junction box gasket
junction box with
and grounding terminal
socket head screw
screw terminal block
(see note)
grounding screw
and cup washer
Junction Box Solenoid
Note:
Junction box with screw terminals
shown. With screw terminal
block removed, remaining parts
comprise the junction box for
spade terminal construction.
See
torque chart
above
or Screw Terminals
(5/32I hex key wrench)
1/2I conduit connection
with 1/4I Spade Terminals
Figure 5. Junction box (optional feature)
gland nut
gland gasket
washer
socket head screw
gasket
DIN terminal
connector
connector cover
center screw
adapter
gasket
(see note 1)
DIN connector
terminal block
(see note 2)
Indicates that these parts are included
Open-Frame Solenoid
with DIN Terminal
Notes:
1. Connector cover may be
position shown for alternate
position of cable entry.
2. Refer to markings on DIN
connector for proper
electrical connections.
in DIN plug connector Kit No. K236034
See
torque chart
above
Plug Conector
(5/32I hex key wrench)
rotated in 90_ increments from
Figure 6. DIN plug connector kit No. K236034 (optional feature)