Xylem IM098 AQUAVAR Model 56 Controller - Manual (Page 16)

Change Pressure without Remote Control (continued)
3) The LED color changes to orange.
4) Now you could change the pressure with the
and buttons. The set pressure is read
off a gauge on the pump discharge.
5) If there is no change to the setting for more than
5 seconds, the AQUAVAR Model 56 Controller
returns to normal operation automatically, and
the new required pressure is stored.
6) The pump can only be STARTED with the
button or STOPPED with the button.
Both buttons are on the front plate of the
AQUAVAR Model 56 Controller.
If the direction of rotation was not correct,
remove all power from the AQUAVAR Model 56
Controller and wait 5 minutes. Open the motor
conduit box and exchange any two of the three
motor leads. Close the conduit box.
Repeat the above steps.
LED description
Orange Solid – The external programming device is connected. Required pressure can be
changed with the buttons and .
Orange Fast Flashing – Connected remote control and the pump is running.
Orange Slow Flashing – Connected remote control the inverter is on and the pump is stopped
because required pressure is reached.
Green Solid – Motor is not running. (Open external stop with terminals X2/4; X2/5 or the item
is stopped with the button on the front plate.
Green Slow Flashing – Inverter is active, but the motor has stopped.
Green Fast Flashing – Motor is running.
Red Solid – Error.
Red Flashing – Fatal error (AQUAVAR Model 56 Controller has to be disconnected from the power
supply).
General Instructions for working with the external programming
device.
With the and ➔ keys you can select the different parameter windows in the menu. To enter a submenu
press the button. To leave the submenu, press and hold the ➔ or the for more than 3 seconds.
Each change in the settings are stored after leaving this parameter window with the or ➔. During
saving “SAVE PARAMETER” is shown on the display of the programming device for a short time.
Installation Procedures
11
▼
▼
▼
▼
➔
➔ ➔
➔
➔
➔
▼