Xylem IM098 AQUAVAR Model 56 Controller - Manual (Page 17)

12
Connecting the External Programming Device to the
AQUAVAR Model 56 Controller
After connection of the AQUAVAR Model 56 Controller to the power supply and attachment of the external
programming device, one of two different messages will be shown:
1) If the AUTOCONNECTION is disabled
(standard) you see:
•This message is shown, when the Remote
Control is first connected. At this time the
AQUAVAR Model 56 Controller searches for
an available address.
•If address 01 is available, the display changes
to:
The actual pump address is shown.
•If the actual pump address 01 is not available
the display does not change and you will see
again:
Then you could change the address with
and and confirm the selected address
with ➔.
When you are connected to a system with more than one pump, connected together over the
interface, you can select with and , the address of the pump you want to talk to and confirm
the selected address with ➔. Status information is shown as follows:
P1: Masterpump
P2: Slavepump
P3: Slavepump
P4: Slavepump
P: Number is not used
Hold: Pump stops through the pressure transmitter
Run: Pump runs
Stop: Pump stops through the lead pump
Disabled: Pump stops through the stop button or the terminal block
Error: Pump stops through an error
Installation Procedures
ADDRESS 01
LOST
ADDRESS 01
DETECTED
ADDRESS 01
LOST
➔
➔
➔
➔