Xylem Aquontroller - Manual (Page 45)

en en en en
45
5.2 MAINTENANCE MENU 5.2 MAINTENANCE MENU 5.2 MAINTENANCE MENU 5.2 MAINTENANCE MENU
During normal operation, you can access to the Maintenance menù that allows you to view and modify
some parameters in addition to the Rapid installation menù.
To access the maintenance menù press + key for about 3 seconds +.
The navigation method, parameter editing and saving is the same as described in section 5.1.
During the display of parameters if you wish to return to the initial display it will be necessary to arrive at
the bottom of the list until you see the writing on the display:
Save & Exit
With ENTER
Press the ENTER butotn to exit from the Maintenance menu and modified parameters are saved in the
memory.
Factory s
Factory s Factory s Factory settings ettings ettings ettings
Access to the Maintenance menu by holding down the key + for about 3 seconds.
Press the key -> and the display will show the parameters for the Maintenance menu. Through all the
parameters until the display shows:
Load Default
0
Press + to set 1
1 1 1.
Press ENTER ENTER ENTER ENTER and hold it down until Done Done Done Done is displayed.
The display shows:
Default OK
This procedure restores the factory settings and AQUONTROLLER will automatically switch off and then
back on again.