YSI 600DW-B Sonde - Manual (Page 18)

Sondes Section 2
There are a variety of probe options for the sondes. The figures below
and to the right illustrate the uses of the common tool for port plug
removal. Note that this tool will also be used to install the various
probes.
If the tool is misplaced or lost, you may use 7/64” and 9/64” hex keys as
substitutes.
OPTIC
PORT PLUG
INSTALLATION
TOOL
DO, COND., &
pH/ORP PORT
PLUGS
INSTALLATION
TOOL
NOTE: You may need pliers to remove the ISE port
plugs, but do not use pliers to tighten the ISE probes.
Hand-tighten
only.
Now refer to the figures below to find the probe locations
in your sonde.
600DW-B SONDE BULKHEAD
ISE PORT PLUG
PLIERS
(SLIP JAWS)
‰ 6572 Free Chlorine = 3-pin connector
FREE
CHLORINE
6572
CONDUCTIVITY/
TEMPERATURE
6560
ALL ISE
PROBES
‰ 6560 Conductivity/Temperature = 6-pin connector
‰ 6561 pH = 4-pin connector
‰ 6565 Combo pH/ORP = 4-pin connector
‰ 6566 Fouling Resistant pH//ORP = 4 pin connector
‰ 6561FG pH (Flat Glass) = 4-pin connector
‰ 6565FG pH/ORP (Flat Glass) = 4-pin connector
YSI Incorporated Drinking Water Monitoring Systems Operations Manual 2-11