YSI 600DW-B Sonde - Manual (Page 91)

Sondes Section 2
2.9.6 REPORT
The Report menu allows you to configure all reports displayed by the sonde software. You will be able to
select which parameters and units of measure that are displayed during operation.
Select
6-Report from the sonde Main menu. The following menu, or a similar menu, will be displayed.
The parameters listed depend on both the sensors available and enabled on your sonde. Therefore your
screen may not be identical to that shown below.
Select
Report from the Main sonde menu to setup the report section. The Report Setup menu will be
displayed.
-------------Report setup--------------
1-(*)Date A-( )Cl2 chrg
2-(*)Time hh:mm:ss B-( )pH
3-(*)Temp C C-( )pH mV
4-(*)SpCond uS/cm D-(*)Orp mV
5-( )Cond E-( )PAR1
6-( )Resist F-( )PAR2
7-( )TDS G-(*)Turbid NTU
8-( )Sal ppt H-(*)Chl ug/L
9-(*)Free Cl2 I-( )Fluor %FS
Select option (0 for previous menu):
The asterisks (*) that follow the numbers or letters indicate that the parameter will appear on all outputs
and reports.
To turn a parameter on or off type the number or letter, that corresponds to the parameter, after
Select option. The parameters “PAR1” and “PAR2” are associated with a special sonde equipped with a
sensor for Photosynthetically Active Radiation (PAR) which can be purchased from the YSI
Massachusetts, but is not likely to be useful in drinking water studies See
Section 8 of this manual for
contact information if you have questions about this sensor.
Note that the units of turbidity are automatically presented as “turbid NTU” if a 6026 sensor has been
selected and “turbid+ NTU” if a 6136 sensor has been selected. The different designations are designed to
differentiate the data from the two sensors types in later analysis.
For parameters with multiple unit options such as temperature, conductivity, specific conductance,
resistivity and TDS, a submenu will appear as shown below, allowing selection of desired units for this
parameter.
--------------Select units-------------
1-(*)NONE
2-( )Temp C
3-( )Temp F
4-( )Temp K
Select option (0 for previous menu): 2
YSI Incorporated Drinking Water Monitoring Systems Operations Manual 2-84