Xylem pHotoFlex/pHotoFlex Turb - Manual (Page 23)

pHotoFlex / pHotoFlex Turb Operation
23 ba75491d04 07/2006
4 Operation
4.1 Switching on the meter
Switching on Press the <ON/OFF> key.
For 30 seconds, Start menu appears with a selection of the measuring
modes. The measuring mode last selected is highlighted.
The status line indicates the meter designation and the version number
of the software.
After a few seconds, the meter automatically switches to the measuring
mode and measured parameter used last.
The measured value display appears (here, e.g. measuring mode Pho-
tometry).
With <M> (long pressure) change the measuring mode.
With <M> (short pressure) toggle between the different measured pa-
rameters in the selected measuring mode.
Switching off Press the <ON/OFF> key.
Automatic switchoff The meter has an automatic switchoff function in order to save the bat-
teries or accumulator pack (see section 4.4). The automatic switchoff
switches the meter off if no key is pressed for an adjustable period.
The automatic switchoff is not active
! if the power is supplied by the power pack (optional),
! if the power is supplied by the LabStation (optional),
! if the Timer or Analysis timer function is on.
Photometry
Turbidity
pH & ORP
i pHotoFlex V 0.24
Start
Photometry \ Concentration
i Select program
with <PROG>
01.02.05 15:12