Xylem pHotoFlex/pHotoFlex Turb - Manual (Page 31)

pHotoFlex / pHotoFlex Turb Operation
31 ba75491d04 07/2006
4.3.4 Navigation example 2: Setting the date and time
The meter has a clock with a date function. The date and time are indi-
cated in the status line of the measured value display. When storing
measured values and calibrating, the current date and time are auto-
matically stored as well.
Numerals are generally entered via the number keys.
The correct setting of the date and time and date format is important for
the following functions and displays:
! Current date and time
! Calibration date
! Identification of stored measured values.
Therefore, check the time at regular intervals.
Note
After a fall of the supply voltage (empty batteries or accumulator pack),
the date and time are reset to 01.01.2003, 00:00 hours.
Setting the date, time
and date format
The data format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
8 To make further settings, switch to the next higher menu level
with <ESC>.
or
Switch to the measured value display with <M> (short pres-
sure).
The instrument is in the measurement mode.
1 In the measured value display:
Open the Configuration menu with <MENU>.
The instrument is in the configuration mode.
2 Select and confirm the System / Continue ... / Date/time menu
with <
▲> <▼> and <START/ENTER>.
Time : 14:53:40
Date : 30.10.03
Date format : dd.mm.yy
Date/time