Xylem OxiTopIS OC100 - Manual (Page 101)

Supplement to the operating manual Supplement to the operating manual
2 BA31114e05 07/2006 BA31114e05 07/2006 3
Restore data
In case you lost your controller or your controller is defective, the “Restore data“
function facilitates to restore the data of running measurements using a new or
another controller. This means the data are not lost.
To perform this function the memory of the controller must be absolutely
empty. The data of each single measuring head are restored one after
the other in a sequence. It is not possible to leave this function and to
continue it afterwards because then the memory would no longer be
empty.
Use to select the
“Restore data“ submenu.
Confirm the restoration for one
measuring head and hold the
controller to the measuring head.
Contact selection:
The controller displays the serial
number of the selected
measuring head.
After reconfirming the data of the
measuring head is read out and
stored in the controller.
The Id number of the sample is not restored, it is always
I
999.
The controller returns to the
“Restore data“ menu.
Perform this procedure for every
measuring head with a
measurement running, without
leaving the “Restore data“
function.
If the data of a measuring head was already restored the following is displayed for
approx. 3 seconds:
Then the controller returns to the
“Restore data“ menu.
Perform the restoration with
another measuring head.
If the memory of the controller is not empty the following is displayed for approx.
3 seconds:
After this, the “maintanance“
menu is displayed again.
It is not possible to restore the
data with the controller.
Contact the WTW service
department.
It is possible to restore the data of all running measurements if the
controller is in the Routine BOD operating mode. In the sample
management, however, only the samples started in the Routine BOD
mode are shown in this case. To have all samples shown, switch over to
the Standard BOD operating mode (see chapter GLP/Tools).