Xylem OxiTopIS OC100 - Manual (Page 54)

GLP / Tools GLP / Tools
54 BA31114e5 07/2006 BA31114e5 07/2006 55
Settings Here you can undertake or change the following settings:
Operating mode
Measuring time
Date/time
* GLP; calibrating interval
Memory
* AutoTemp
* Switch-off interval
Language
Check Show (finished/all)
info (with report printout)
Controller info (with report printout)
Cal test
Pneumatic test
Maintenance Erase finished samples (in the controller - sample management)
Reset/release
* only in the standard BOD operating mode
Show free
Main menu, “GLP/Tools“.
The “Show free
“ menu
is preselected.
Press .
Point the controller at the measuring
heads: 40 cm to 100 cm
All free measuring heads flash for approx.
5 seconds.
Show settings
Main menu, “GLP/Tools“.
Use to select
the “Show settings“ menu.
The following example illustrates the presettings in the Standard
BOD operating mode.
“Show settings“ menu: A list
containing the current settings is
displayed.
Use
to scroll through the list where
the scrolling stops at the
beginning and end of the list
In the “Show settings“ submenu:
Print out the whole list of current settings (as in the display).