Xylem OxiTopIS OC100 - Manual (Page 25)

Operating Mode: Routine BOD Operating Mode: Routine BOD
24 BA31114e5 07/2006 BA31114e5 07/2006 25
Call up data - Stop
If a measuring head is missing or
defective and the controller
cannot transfer the data as a
result, the menu item “Stop“ is
provided.
After confirmation, the display
message shown here appears.
Then:
“Show
“:
As in “Show sample“ but used selectively for missing measuring
heads (identification option if only the sender of the measuring head
is defective. Otherwise identify missing measuring heads using
“Show all“ (see the chapter “GLP/Tools”).
“Missing
“:
Using this you can remove the data of a missing or defective
measuring head from the sample management of the controller.
Erase:
Removes missing samples from
the data stock.
Return:
Jumps back to the previous
menu.
Evaluation
Starting point: sample
management.
Use
to select a sample.
Enters into the evaluation:
Display of the selected sample as
a curve together with measured
value data.
Change to cursor prompt:
Pressing causes the
cursor (crosswire) to run through
the points of the curve. The
allocated run time and the
corresponding measured value
are each displayed.
Pressing changes between the cursor prompt and
display of the curve together with the measured value data.