Xylem OxiTopIS OC100 - Manual (Page 66)

GLP / Tools GLP / Tools
66 BA31114e5 07/2006 BA31114e5 07/2006 67
info
“Check“ menu.
Use to select “
info “ .
The measuring head flashes and
a display appears on the
controller giving the following
information:
- serial number of the measuring
head,
- battery status
(OK/LOBAT/EMPTY!!),
- the next calibration date
(only in the measuring mode,
Standard BOD and GLP “On“
- status of the measuring head
(free/used/defective).
If the measuring head is “used“,
use to scroll through the
display of further information:
- start date
- final date
- sample number
- type and
- range for the measurement
Return to the “Check“ menu
using .
Repeat the procedure for each
measuring head.
If the measuring head does not respond, the following display
appears after approximately 7 seconds:
The query was stopped.
You can select between
- continue query (see above) and
- Stop (return to the
“Check“ menu
Controller info
“Check“ menu.
Use to select
“Controller info“.
The display shows the following
information:
- number of measuring heads for
which there is still memory
capacity
- status of the supply batteries
- status of the data backup
batteries
(OK/LOBAT).
Use to scroll to the
specification of the
- software version
- Ser.no.
(can differ from the example
shown here)
Return to the “Check“ menu
using .