Extron Electronics MLS 608 D Series User Guide - Manual (Page 17)

f
Analog MTP output (audio and video) — This output transmits signals from an
active analog input over CAT 5 cable to the MTP/HDMI U R receiver. It is also capable
of transmitting line level mono audio over the same cable as audio output 3.
The output also supports pre-peaking adjustment for optimizing video signals for long
cable runs.
Skew adjustment is available on this ouput, compensating for up to 64 nanoseconds
of skew. Adjustments are made using DSP Configurator software or SIS commands.
Settings are stored in the memory and recalled when the input is selected.
Connect the MTP HDMI U R twisted pair receiver (supplied) for analog audio and
video output.
NOTES: • See the table on page 9 for pinout details .
• See the table on page 10 for output transmission distances.
g
Digital Inputs 5-8 — These four HDMI inputs are HDMI 1.3 compatible and have the
following features:
z
HDCP authentication – The MLS 608 D gives a status feedback if it detects any
of the following are valid:
z
If a source is HDCP compliant
z
If a source has active video
z
If a display is HDCP compliant (only if connected input is encrypted)
If the source is HDCP compliant but the display is not, the MLS displays a green
screen at the output.
See "HDCP Compliance" within the "DSP Configurator" section, for the detailed
method of HDCP detection and operation.
z
Digital input equalization — Each digital input has automatic equalization to
compensate for distance from the source to the input. This gives 1080p, 8-bit
color, with a maximum distance of 50 feet using Extron Pro Series HDMI cable.
NOTE: The transmission distance varies greatly depending on the signal
resolution, and on the type of cable, graphics card and display used in
the system.
z
Audio de-embedding — Each of the HDMI inputs de-embed 2-channel PCM
audio signals at 48 Hz only. Other audio signals are not de-embedded: the signal
will be muted at the DSP processor and audio will not be heard.
The audio to be de-embeded is user selectable from either the existing embedded
digital audio or a local analog input. The default is digital audio.
Connect up to four digital HDMI and DVD-D inputs to
the HDMI connectors
g . Connect DVI-D sources using an
adapter cable and secure the connectors to the
MLS 608 D using the LockIt
™ bracket as follows:
1. Plug the HDMI cable into the panel connection.
2. Loosen the HDMI connection mounting screw
from the panel enough to allow the LockIt
lacing bracket to be placed over it.
3. Place the LockIt lacing bracket on the screw
and against the HDMI connector, then tighten
the screw to secure the bracket.
3
4
3
1
2
MLS 608 D Series • Rear Panel Connections 11