Copying a block of elements, Cutting a block of elements, Pasting to a single location – Extron Electronics MLS 608 D Series User Guide User Manual
Page 84: Pasting to a single, Location
Copying a Block of Elements
1.
Select the elements to be copied
2.
Use one of the following methods to copy the elements:
z
Right-click the selection and select Copy from the drop-down menu.
z
From the Edit menu, select Copy.
z
Press <Ctrl + C> on the keyboard.
Cutting a Block of Elements
When an element is cut, the element is not removed until it has been pasted.
1.
Select the elements to be cut (see the "
" subsections above).
2.
Use one of the following methods to cut the elements:
z
Right-click the selection and select Cut from the drop-down menu.
z
From the Edit menu, select Cut.
z
Press <Ctrl + X> on the keyboard.
Pasting to a Single Location
A selected block of elements can be cut or copied, then pasted to a single location.
To paste a block of elements to a single location:
1.
Click the upper left-most element that matches the upper left-most element of the
area that you cut or copied.
2.
Use one of the following methods to paste the elements:
z
Right-click on the upper left element and select Paste from the drop-down
menu.
z
From the Edit menu, select Paste.
z
Press <Ctrl + V> on the keyboard.
In the figure below left, all of the processor blocks in the top two rows have been selected
(the upper left-most block is a filter block) and then cut or copied. In the figure below
right, the upper left-most block has been selected (also a filter block) in the area to which
the elements will be pasted. The first two rows will be pasted to the second two rows.
MLS 608 D Series • User Interface Navigation
78