Audio and rs-232 connections, Caution – Extron Electronics MLS 608 D Series User Guide User Manual

Page 20

Advertising
background image

Audio and RS-232 Connections

NOTES:

When wiring the connectors for the ports listed below:
• DO NOT tin the wires.
• Bare the wires to a maximum length of 3/16 inch (5 mm) only.

i

Audio inputs 1-3 and 5-8 — These 5-pole captive screw connectors support analog,

balanced or unbalanced, stereo audio as three line level inputs (1-3) and four line level
analog stereo inputs (5-8).
Audio from the HDMI inputs 5-8 can be de-embeded from the HDMI source. This
allows the user to choose to select audio either from the HDMI inputs or the analog
audio from these four captive screw inputs. Once an audio source is selected, the
unselected source is disabled. The default selection is audio from the HDMI inputs.

Connect audio sources to these 5-pole, captive screw connectors. Wire the connector
for line level analog stereo as shown below.

LR

Unbalanced Input

Balanced Input

Ring

Sleeve (s)

Tip

Sleeve

Tip

Sleeve

Tip

Tip

Ring

j

MIC/Line level audio inputs 1-2 These two 3-pole, captive screw connectors are

microphone or line level inputs for balanced or unbalanced mono audio. They also
have +48 V phantom power support and two rear panel LEDs that indicate when
phantom power is activated. The phantom power can be activated through
DSP Configurator. See the DSP Configurator Help File "Mic/Line Input Gain" section,
for the method of enabling and disabling phantom power.
Connect microphone or line level audio inputs to these 3-pole, captive screw
connectors. Wire the connector for mono audio as shown below.

Balanced Mic Input

Unbalanced Mic Input

Tip

Ring

Sleeve

Tip

Sleeve

k

Line level audio outputs 1-2 — Connect audio output devices to these 5-pole,

captive screw connectors.
Wire the connectors for line level analog stereo output as shown below.

Unbalanced Output

Balanced Output

Tip

NO Ground Here

Sleeve(s)

Tip

NO Ground Here

LR A

UDIO

Tip

Ring

Sleeve(s)

Tip

Ring

LR A

UDIO

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground contact.

DO NOT

connect the sleeve(s) to the negative (-) contacts

.

MLS 608 D Series • Rear Panel Connections

14

Advertising