Extron Electronics MLS 608 D Series User Guide - Manual (Page 26)

Operation
This section of the manual discusses the operation of an MLS 608 D device, and is divided
into four sections:
z
Front Panel Features and Operation
z Using EDIDs
z Optimizing Audio — An Overview
z
Optimizing Video — An Overview
z Firmware Upgrades
Front Panel Features and Operation
All MLS 608D models have the same front panel configuration.
MLS 608 D
AUX
VID PC DOC
CAM Blu-ray
VOLUME SOURCE SELECTION
CONFIG R
MIC VOLUME
AV Switcher with ProDSP ™
LAPTOP
1 2 3 4 5 6 7 8
4 5 3 2 1 6
Figure 11. MLS 608D Device Front Panel Features
a
Power and reset status LED
d
Source selection buttons
b
Reset button
e
Volume control knob
c
Front panel mini USB configuration port
f
Mic volume control knob
a
Power/reset status LED — This LED lights green when power is applied, and amber
when in power save (standby) mode.
It also indicates reset mode when the reset button is pressed (see method below).
b
Reset button — Press and hold this recessed button to reset the MLS switcher to one
of the two available reset mode: modes 1 and 5.
Reset as follows:
Mode 1 — Revert to factory firmware version where incompatibility issues
occur with user loaded firmware.
To reset temporarily to the factory default firmware, press and hold in the reset button
while applying power to the unit.
NOTES: • After a Mode 1 reset, update the firmware to the latest version.
DO NOT use the factory firmware resulting from the reset.
Factory firmware must be re-uploaded if that is the version to be used.
• If you do not want to update the firmware, recycling the power reinstates the
firmware version used before the Mode 1 reset.
MLS 608 D Series • Operation 20