Extron Electronics MLS 608 D Series User Guide - Manual (Page 85)

Pasting to Multiple Locations
A selected block of elements can be cut or copied, then pasted to multiple locations.
To paste a block of elements to multiple locations:
1. Click the upper left-most element that matches the upper left-most element of the
area that you cut or copied.
2. Press and hold the <Ctrl> key while repeating step 1 for every area to which you want
to paste. Make sure that the area to which you are pasting will not overlap.
3. Release the <Ctrl> key.
4. Use one of the following methods to paste the block of elements.
z
From the Edit menu, select Paste.
z
Press <Ctrl + V> on the keyboard.
In the figure below left, all of the processor blocks in the top two rows have been selected
(the upper left-most block is a Filter block) and then cut or copied. In the figure below
right, the upper left-most blocks have been selected (also Filter blocks) for each set of two
rows to which to paste. The first two rows will be pasted three times.
MLS 608 D Series • User Interface Navigation 79