Extron Electronics MLS 608 D Series User Guide User Manual
Page 52
Figure 32.
The Default Audio and Video I/O Workspace in Emulate Mode
For the MLS 608 D, the DSP Configurator has four workspaces:
z
Audio and Video I/O workspace
z
Audio I/O workspace
z
Video I/O workspace
z
Console View workspace
Each workspace provides a map of all input and output signal paths inside the main
application window. Within these workspaces you can configure various settings related
to audio and video such as audio gain, trim, volume controls, and video format, as well as
setting video ties in follow or breakaway mode.
NOTE: When the program is running, access the Help file (Help > Contents or
press <F1>) to see the detailed procedures for using DSP Configurator.
DSP Configurator can be used in either of two operational modes: Live and Emulate. From
the blank Emulate mode configuration it is possible to build a configuration and a set of
presets. Alternatively you can open an existing file that contains the last configuration
displayed and any saved presets.
In Emulate mode, the video signal presence and HDCP status indicators (at lower left of
workspace window) are grayed out. When in Live mode these are fully functional
(
). In addition when DSP Configurator is in Live mode, two communication
indicators (Transmit and Receive) appear at the lower right corner of the workspace.
MLS 608 D Series • DSP Configurator
46