Alpha Technologies AlphaGen PN-6x-T 7.5kW 48VDC - Installation and Operation Manual - Manual (Page 27)

745-020-B0-003, Rev. C 27
Fig. 3-2, Pallet Bolt Locations
3.0 Installation, continued
3.1 Transportation
The enclosure as shipped contains the Auxiliary Power Unit (APU) and, therefore, is heavy
(approximately 338 lbs). A safe means of transportation to the site and unloading the
enclosure must be considered. Do not transport, lift, or place the unit on any surface unable
to fully support its weight.
The system is shipped bolted to a pallet. Once the system arrives, remove the protective
outer wrapping material and inspect the outside of the enclosure for shipping damage. Use a
forklift to place the unit (still bolted to its pallet) in the back of the transport vehicle for delivery
to the installation site. Once on site, attach the lifting plates to the enclosure at the holes
indicated below. Remove the front and rear doors and remove the pallet mounting bolts using
a 5/8" socket wrench.
The ignition battery MUST NOT be installed until the enclosure is set in place at its permanent location.
Pallet Mounting Bolt
(hidden)
Pallet Mounting Bolt
(hidden)
Lifting Plate
Mounting Holes
Lifting Plate
Mounting Holes
CAUTION!