Alpha Technologies AlphaGen PN-6x-T 7.5kW 48VDC - Installation and Operation Manual - Manual (Page 62)

62 745-020-B0-003, Rev. C
Fig. 7-1, Air Filter Removal
Filter Removal, Replacement, and Cleaning:
1. Unlock and remove the enclosure rear door.
2. Locate and loosen the fi lter bracket thumbscrew on the inside wall of the enclosure,
opposite the air intake vent.
3. Lower the bracket and remove the fi lter.
4. Clean or replace the fi lter and reinstall in the reverse order. Clean the fi lter using a
vacuum or compressed air to remove loose dust or dirt. After cleaning, use compressed
air to dry the fi lter.
7.0 Maintenance, continued
7.2 Filter Cleaning
The air intake fi lter (Alpha P/N 561-216-10) is located inside the air intake vent on the side of
the enclosure.
Failure to keep the fi lter clean, or using improperly installed fi lters, may cause system failure due
to dirt buildup or lack of cooling air. Equipment failures caused by fi lter blockage, incorrect fi lter
substitution, or dirt ingress due to clogged or improperly installed fi lters are not covered under
warranty.
X
Loosen thumbscrew on inside of
enclosure and lower the bracket.
Filter Bracket
CAUTION!