B&K Precision 2552-2559 - Programming Manual - Manual (Page 89)

89
DESCRIPTION The *RCL command sets the state of the
instrument, using one of the ten non-volatile
panel setups, by recalling the complete front-
panel setup of the instrument. Panel setup 0
corresponds to the default panel setup.
The *RCL command produces the opposite
effect of the *SAV command.
If the desired panel setup is not acceptable, the
EXecution error status Register (EXR) is set and
the EXE bit of the standard Event Status
Register (ESR) is se
t.
COMMAND SYNTAX
*RCL <panel_setup>
<panel_setup>:= 0 to 20
EXAMPLE The following recalls the instrument setup
previously stored in panel setup 3:
Command message:
*RCL 3
RELATED COMMANDS PANEL_SETUP, *SAV, EXR
SAVE/RECALL SETUP *RCL
Command