Hach-Lange AMTAX indoor sc - Manual (Page 13)

13
Section 3 Installation
DANGER
Only qualified personnel should conduct the tasks described
in this section of the manual.
CAUTION
The enclosure may tip forwards if it has not been fixed in
place. Only open the enclosure if the enclosure is properly
mounted.
DANGER
Potential danger in the event of contact with
chemical/biological materials. Handling chemical samples,
standards and reagents can be dangerous. Familiarize
yourself with the necessary safety procedures and the correct
handling of the chemicals before the work and read and follow
all relevant safety data sheets.
Normal operation of this instrument may involve the use of
hazardous chemicals or biologically harmful samples.
• Observe all cautionary information printed on the original
solution containers and safety data sheet prior to their
use.
• Dispose of all consumed solutions in accordance with
national regulations and laws.
• Select the type of protective equipment suitable to the
concentration and quantity of the dangerous material at
the respective work place.
3.1 Basic installation overview
1. Unpack the instrument ( section 3.2 ).
2. Mount the instrument ( section 3.3, page 14 ).
3. Remove any transport locks ( section 3.4.2, page 19 ).
4. Install the collecting tray and the humidity sensor ( section 3.4.3,
page 21 and section 3.4.4, page 22 ).
5. Determine the appropriate installation option ( section 3.4.5,
page 23 ).
6. Mount the Filter Probe sc or Filtrax, if necessary. Refer to the
appropriate manual for more information.
7. Connect the Filter Probe sc or Filtrax to the AMTAX sc, if
necessary. Refer to section 3.5.3, page 26 for the Filter Probe
sc. Refer to the Filtrax manual for more information.
8. Connect the Drain Heating Connection, if necessary.
9. Make all plumbing connections ( Appendix A Plumbing and
Connection Options, page 77 ).
10. Install the reagents and prepare the Electrode and Electrolyte
( section 3.6, page 29 and section 3.7.1, page 31 ).
11. Connect the AMTAX sc to the sc1000 controller to supply
power to the system ( section 3.8, page 33 ).
12. Connect the data network ( section 3.9, page 34 ).