Hach-Lange SI794 D User Manual - Manual (Page 61)

Two complete parameter sets are stored in the EEPROM.
As delivered, the two sets are identical but can be edited.
Note:
Fill in your configuration data on the following pages.
Code. Parameter Default setting
o1. Sensor type A
o1. %, mg/L, ppm %
o1. 0/4-20 mA 4-20 mA
o1. Current start 0000 %
o1. Current end 0500 %
o1. Filter time 0 sec
o1. 22mA signal OFF
o1. HOLD response Last
o1. Fix current 021.0 mA
o2. Unit °C / °F °C
o2. Temp probe 22 NTC
o2. 0/4 ...20mA 4-20 mA
o2. Current start 000.0 °C
o2. Current end 100.0 °C
o2. Filter time 0 sec
o2. 22mA signal OFF
o2. HOLD response Last
o2. Fix current 021.0 mA
Co. Polariz. voltage 675 mV
Co. Pressure unit bar
Co. Pressure 1.013 bar
Co. Salinity 00.00 mg/L
CA. Cal mode Sat
CA. Cal interval 0000 h
AL. Sensocheck OFF
AL. Alarm delay 0010 sec
AL. LED Hold OFF
Code. Parameter Default setting
rL. Relay function Limit
L1. Contact function Lo
L1. Contact response N/C
L1. Setpoint 0000 %
L1. Hysteresis 0001 %
L1. Delay 0010 sec
L2. Contact function Hi
L2. Contact response N/C
L2. Setpoint 0500 %
L2. Hysteresis 0001 %
L2. Delay 0010 sec
Ct. Setpoint 0100 %
Ct. Neutral zone 0010 %
Ct. P action 0100 %
Ct. I action 0000 sec
Ct. D action 0000 sec
Ct. PLC/PFC controller PLC
Ct. Pulse length 0010 sec
Ct. Pulse frequency 0060 /min
Ct. Hold response Last
Cn. Rinse/Par.set 2 rinse
Cn. Rinsing interval 000.0 h
Cn. Rinse time 0060 sec
Cn. Contact type N/C
Default settings of parameter sets
61