Number - 11 complete one of the following steps, Start number - 1 boot the server, Number - 7 press f3 to specify another path – Adaptec 5ANA-940 User Manual
Page 100: Installing and configuring the atm software after, Installing netware 4.1 8-10
8-10
ANA-5910/5930/5940 User’s Guide
10
From the Board ALANE_1 (Driver ALANE) Actions menu,
select Save parameters and continue and press Enter.
The following message appears:
Do you want to select an additional Network driver?
11
Complete one of the following steps:
a
If you do not want to install additional drivers, select No
and press Enter.
b
If you want to install additional drivers, select Yes and press
Enter.
The Select a driver to install menu appears. Refer to your
Novell NetWare documentation for information about
installing drivers from other manufacturers.
12
In the Choose the Server Driver - Summary screen, select
Continue installation
from the Driver Options menu and
press Enter.
13
Continue with the Novell NetWare 4.1 installation procedure.
Installing and Configuring the ATM Software After Installing
NetWare 4.1
To install the Adaptec ATM software for Novell NetWare 4.1
1
Boot the server.
2
At the server system console prompt, type the following
command and press Enter:
load install
3
From the Installation Options menu, select Driver options and
press Enter.
4
From the Driver Options menu, select Configure network
drivers
and press Enter.
5
From the Additional Driver Actions list, select Select a driver
and press Enter.
6
At the Select a driver menu, press Insert to install an unlisted
(the Adaptec ATM) driver.
7
Press F3 to specify another path.