Adaptec 5ANA-940 - Manual (Page 121)

B-3
Windows NT Specific Error Messages and Diagnostics
Diagnostics Error Messages
Diagnostic error messages appear at the command line when
running the
aatmdiag.exe program.
ioctl link failure An error was encountered while doing
I_PLINK or I_PUNLINK between
aarp.sys ,
and atmo.sys drivers.
Value <value> out of
bounds The value in the configuration file is out of
bounds.
Diagnostic Error Message Description
Error: Invalid loop
count entered. Must be
positive integer number A negative or zero loop count is invalid for
the
loop command.
Error: Unable to setup
diagnostics. Check if
atmo driver is busy The driver is busy; several possible causes are
listed below:
Another application is using the
atmo.sys
driver (another aatmdiag.exe is currently
active). Terminate the application using the
atmo.sys driver. For Classical IP, use
acipcnfg.exe . For an active ARP, use
net stop aarp .
An invalid controller number was specified
while invoking
aatmdiag -c # . Valid controller
numbers range from 0 to N , where N is equal
to the total number of physical boards in the
system minus 1. Only one adapter is
supported in a system at this time (enter
0 ).
The atmo.sys driver was not loaded properly.
Reconfigure the driver or reinstall the driver.
SYSTEM Error: No such
file or directory File: X The file does not exist when using the aatmdiag
-f X option. Make sure this file exists.
Error Message Description