Adaptec 5ANA-940 - Manual (Page 64)

5-16
ANA-5910/5930/5940 User’s Guide
10 Select PCI from the Bus Type drop-down list in the Bus
Location dialog box, and select the bus number to which the
ATM adapter is attached from the Bus Number drop-down list.
Then select OK.
The installer copies the base driver to the following directory:
drive:\systemroot\System32\drivers
where
11 When the Setup Message dialog box appears, insert Device
Driver for Windows NT Disk 2 in the diskette drive, and select
OK
.
12 If NT SNMP has not been installed on your workstation, the
Setup Message dialog box appears advising you to install the
NT SNMP service and to configure the Adaptec ATM SNMP
agent. Select OK.
When the Network Settings dialog box appears, the ATMO
(base) Driver appears in the Installed Network Software list
box, and the Adaptec ATM adapter appears in the Installed
Adapter Cards list box.
13 Select OK to exit the Network Settings dialog box.
14 If TCP/IP is installed on your workstation, the TCP/IP
Configuration dialog box appears, requiring that you set other
protocol addresses and information. Refer to your Windows
NT user documentation for information about setting up your
TCP/IP configuration, and when you have entered the
necessary TCP/IP data, select OK. If you do not have TCP/IP
installed, these configuration screens will not appear.
15 Select Restart Now.
drive = boot drive letter
systemroot = SystemRoot directory