1head - troubleshooting, 2head - status commands, 2head - status/error messages – Adaptec 5ANA-940 User Manual
Page 108: Troubleshooting 8-18, Status commands 8-18 status/error messages 8-18, Troubleshooting, Status commands, Status/error messages
8-18
ANA-5910/5930/5940 User’s Guide
Troubleshooting
This section provides status commands and explains various status/
error messages.
Status Commands
Use the following commands to determine ATM software status:
Status/Error Messages
As the ATM driver is loading, status/error messages are logged to
the console.
The message
WARNING: ATMS_SIG: QSAAL Transport Layer Up
Indicates that the ATM NIC is registered to the switch using ILMI
signaling.
The message
alane0: N7500 ELAN is Active.
Indicates that the ATM LAN Emulation driver is up.
The message
atms_addr_reg_timer: No reply from UME:
aatms_get_rev_mp( ) returns null [1] Address retrieval error
Indicates a failure with switch registration. Check the connection to
the switch.
The message
Retrying to Activate ELAN.
Indicates failure with LAN Emulation registration. Check the
configuration for LAN Emulation in the ATM NIC and ATM switch.
The message
WARNING: E1018 ATMS_SIG: QSAAL Transport Layer Down
Indicates a lost of failed connection to the switch. Check the
connection.
aatmcnfg -p
Shows the status of the ATM driver
alancnfg -p
Shows the LAN Emulation status